![]() ![]() ![]() outdoors on a sunny day) and a high ISO setting is more appropriate for low-light situations (indoors without a flash, nighttime shots, etc.). Once you have this right apply the last piece of heat tape half over the bottom cuts and half on the mug to hold the paper in place.In it’s simplest terms, a low ISO setting works best in bright light (i.e. If not you can slip the paper up a down a bit where the cuts are until it is. Now check to see if your text is aligned with the base of the mug. Once this is done apply 1 piece of tape to the center of each end of the paper. Now rotate the paper back and forth until you have roughly the same distance between each end and the handle and the same amount of white ceramic showing at the top and bottom of the paper. Carefully wrap the paper around a mug, image facing inward. So now cut off about 3 pieces of heat tape about 1/2' 12mm long stick them on the edge of your bench. You will also notice that most of the time you can see through the paper so this will help you to align your images so they are horizontal. otherwise your text may not run parallel to the bottom of your mug. What this will allow us to do is once we have taped the paper to the mug with the image facing the mug the cuts allow us to adjust the center of the paper up or down just a little to allow for the taper. All mugs are slightly tapered so before we wrap our artwork around the mug we are going to make two cuts right in the middle of the paper so we end up cutting through about 3/4 of the paper. ![]() ![]() Now we are ready to position our print onto our sublimation mug. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |